Collect and Plant an Acorn to Grow an Oak Tree

Beginning as early as late August and continuing through December, various species of oak acorns are maturing and ripening for collection. Ripening dates vary from year to year and from state to state by as much as three to four weeks, making it difficult to use actual dates to determine maturity. The best time to collect acorns, either off the tree or from the ground, is when they begin falling—just that simple. Prime picking is late September through the first week in November, depending on oak tree species and location within the United States. This tree seed called an acorn is perfect when plump and the cap removes easily. Collecting and Storing Acorns The height of the acorn crop above the ground and the forest understory below can make it very difficult for the casual collector to gather large numbers of acorns in a forest setting. Lawns or paved areas help in collecting acorns if trees are found and prepared before site conditions degrade the nut. Locate open-grown trees that are heavily loaded with acorns and are in or adjacent to parking lots such as at churches or schools. Trees selected in this way also make identifying the acorns species easier. Always identify the tree and place tags or mark the bags so you will know what species you have collected. To store acorns for future planting, put them in a polyethylene plastic bag—a wall thickness of four to ten millimeters is best—with damp peat mix or sawdust. These bags are ideal for storing acorns since they are permeable to carbon dioxide and oxygen but impermeable to moisture. Close the bag loosely and store in the refrigerator at 40 degrees (white oaks can still sprout at between 36 and 39 degrees). Check acorns throughout the winter and keep just barely damp. Red oak acorns need about 1000 hours of cold or about 42 days. Planting these acorns in late April of the following season gives you the best success but can be planted later. Preparing for Planting The two most critical components of caring for acorns that are to be planted are: not allowing the acorns to dry out over an extended period of timenot allowing the acorns to heat up. Acorns will lose their ability to germinate very quickly if allowed to dry out. Keep acorns in the shade as you collect them, and put them in your refrigerator as soon as possible if not planting immediately. Dont freeze acorns. Immediate planting should be limited to the white oak species group including white, bur, chestnut and swamp oak. Red oak species group acorns must be planted in the second season—meaning the following spring. Special Instructions White Oak  acorns mature in one season—the season of collection. White oak acorns do not exhibit seed dormancy and will start to germinate very soon after maturing and falling to the ground. You can plant these acorns immediately or refrigerate for later planting. Red Oak  acorns mature in two seasons. The red oak group has to have some seed dormancy and generally does not germinate until the following spring and with some stratification (a cooling period). If stored properly and kept damp, these red oak acorns can be held in cold storage for planting in late April through early summer. Germinating and Potting After determining the proper time to plant, you should select the best-looking acorns (plump and rot-free) and place those in some  loose potting soil in one-gallon pots or deeper containers. The taproot will grow quickly to the bottom of containers and root width is not as important. Containers should have holes in the bottom to allow for drainage. Place acorns on their sides at a depth of one-half to the width size of the acorn. Keep the soil moist but aerated. Keep the pots from freezing. Transplanting Dont allow an oak seedling’s tap root to grow out of the container bottom and into the soil below. This will break the taproot. If possible, seedlings should be transplanted as soon as the first leaves open and become firm but before extensive root development occurs.​ The planting hole should be twice as wide and deep as the pot and root ball. Carefully remove the root ball. Gently set the root ball in the hole with the root crown at the level of the soil surface. Fill the hole with soil, firmly tamp and soak.